Edelbrock 2010 Manuel d'installation télécharger pdf (Page 31)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 23

148. Use a 15mm wrench to remove two bolts retaining the

power steering reservoir bracket. Use a pair of pliers or

hose clamp tools to disconnect the lower reservoir-to-

pump hose. Note that it is not necessary to fully remove the

reservoir from the engine.

149. Slide the old bracket off the reservoir then install the

supplied bracket using a 15mm socket and the stock bolts.

Slide the power steering reservoir onto the new bracket and

reattach the lower reservoir to pump hose.

150. Line up the supplied templates on the radiator shroud

and drill the appropriate holes, depending on the presence,

or absence, of the factory oil cooler.

151. Reinstall the radiator shroud by sliding it into place

from below then hold it in place using the four stock body

pins (two up front, and one on each side).

152. Clip the passenger side sensor back into place and

reattach the ambient air temperature sensor connector.

153. Use a 10mm socket to remove center air dam bolt.

154. Disconnect horn electrical connector then use a

10mm socket to remove the bolt holding the horn bracket

in place. Remove the horn assembly and set it aside.

155. Use a 10mm socket to install the heat exchanger,

using the 20mm bolts supplied in Bag #2 on the side, and

the stock air dam bolt on the bottom.

156. Use a 10mm socket to remove the nuts holding the

horns to the bracket.

157. Use a small flat blade screwdriver to remove the wire

harness connecting the horns and swap the connectors

from horn to horn.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 40 41

Pas de commentaire

Edelbrock 2010 Manuel d'installation Page 31